Remote Access Code; Message Alert Tone - AT&T BL102 Quick Start Manual

Answering system
Answering system settings

Remote access code

To access your answering system remotely from any touch-tone
phone, you need to enter a two-digit number (00-99). By default,
the remote access code is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/
the main menu.
2. Press q
CID
/SELECT.
MENU
3. Press q
CID
/SELECT.
MENU
4. Press q
CID
/SELECT.
MENU
5. Use the dialing keys to enter a two-digit number. Press
/DELETE to backspace and delete a digit.
MUTE
6. Press
MENU

Message alert tone

When the message alert tone is set to On, and there is at least one
new message, the telephone base beeps every ten seconds. By
default, the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/
main menu.
2. Press q
CID
/SELECT.
MENU
3. Press q
CID
/SELECT.
MENU
4. Press q
CID
/SELECT.
MENU
5. Press q
CID
6. Press
MENU
to scroll to Answering sys, then press
or p
DIR
or p to scroll to Ans sys setup, then press
DIR
to scroll to Remote code, then press
or p
DIR
/SELECT to save the setting.
or p to scroll to Answering sys, then press
DIR
to scroll to Ans sys setup, then press
or p
DIR
to scroll to Msg alert tone, then press
or p
DIR
to choose On or Off.
or p
DIR
/SELECT to save the setting.
71
to enter
SELECT
to enter the
SELECT