Adjusting the projected image
Adjusting the projection angle
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to
each other, the projected image becomes
trapezoidal. You can screw the adjuster feet to
fine-tune the horizontal angle.
To retract the feet, screw the adjuster feet in a
reverse direction.
Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
Fine-tuning the image size and clarity
Adjust the projected image to the size that you
need using the zoom ring.
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the top or
bottom. It occurs when the projector is not perpendicular to the screen.
To adjust the Keystone:
1. Select Settings from BenQ Launcher and press OK, or press
projector.
2. Select Display > Keystone and press OK.
3. Disable the Auto Keystone setting.
4. Select Keystone and press OK.
Sharpen the image by rotating the focus ring.
on the remote control or the
Operation
17