am
mg/dL
Step 1: Remove Assure
Platinum Test Strip from the bottle.
®
Immediately replace the bottle cap tightly.
Insert test strip as shown in the diagram. Meter will turn on automatically.
Verify that all symbols appear on the screen.
Note: If both PCS and
solution test (see back).
The strip and flashing blood drop indicate the meter is ready for use.
Step 2: Obtain a blood sample. Touch the sample application tip at the end
of the strip to the blood drop on your finger.
the blood into the strip.
Note: Apply blood to test strip within 20 seconds of obtaining blood sample. The
meter will start to count down when it detects that blood has been applied. If meter
does not start after adding the first blood drop, remove the test strip and test with a
new test strip. Discard strip if meter does not start to count down.
Important:
The minimum sample volume is 0.5 µL. Smaller samples may not start the meter or
can start the meter count down and provide an E13 error message. Ensure blood
completely fills the reaction site.
Step 3: Meter will count down
The meter will show the result in 7 seconds.
Option: Flagging Test Result in Memory
Results may be marked with an "!" if you feel the result is incorrect or the test
procedure was not followed correctly.
Mark the test result with an "!" by pressing either the Forward or Back button
after result is on screen. Marked results will not be included in the 7-, 14-, 30-, or
90-day averages.
Healthcare
Professionals: Record test result in patient's chart.
The flashing arrow reminds you to remove the test strip. Remove the test strip by holding the
Step 4:
meter so that the test strip points down.
The meter shuts off automatically when you remove the test strip.
test strip.
ASSURE
PROFESSIONAL BLOOD GLUCOSE MONITORING SYSTEM
PERFORMING A BLOOD GLUCOSE TEST
Caution: Failure to follow instructions may cause inaccurate results.
am
appear on the screen, perform a control
Capillary action will pull
by showing "7".
Push the test strip release button forward. Dispose of
PLATINUM
®
Results will be shown in units of mg/dL.
Results will not show a decimal point.
Sample Application Tip
Contact
Insert contact bars
Bars
into meter.
Enough
Not Enough
Blood
Blood
am
mg/dL
Too Much
Blood
am
mg/dL
Need help?
Do you have a question about the ASSURE PLATINUM and is the answer not in the manual?
Questions and answers