Know Your Snow Thrower - Troy-Bilt 10030 Operator's Manual

Auger
Control
Z-End
Jam Nut
Auger
Control Cable
Figure 5
SECTION 3: KNOWING YOUR SNOW THROWER
WARNING:
Be familiar with all the controls on the snow thrower and their proper operation. Know how to
stop the machine and disengage them quickly.
• Compare the figure below and description of controls in this section with your equipment before starting unit.
Traction Control/Auger Control Lock
Gas Cap
Oil Fill
Discharge Chute
Chute Clean-Out
Tool
Augers
Head Light
Tire Pressure (Pneumatic Tires)
The tires are overinflated for shipping purposes.
• Check tire pressure. Maintain pressure between 10
and 14 psi.
NOTE: If the tire pressure is not equal in all tires, the
unit may pull to one side or the other.
WARNING:
any circumstance is 30 psi. Equal tire pressure
should be maintained at all times. Excessive
pressure (over 30 psi) when seating beads
may cause tire/rim assembly to burst with force
sufficient to cause serious injury.
Heated Grip Switch
Chute Tilt Control
Heated Grip
Steering
Control
Skid Shoe
Figure 6
7
Maximum tire pressure under
Wheel Steering Control
Shift Lever
Auger Drive Control
Chute Crank