Troy-Bilt 30245 Operator's Manual page 6

Assembly
Section
3
ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-888-611-6708. If calling for assistance, please have the
model, revision, and serial number from the data tag available.
See "Know Your Generator" for data tag location.
Unpack the Generator
1. Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.
Figure 1 — Install Wheel Kit
Support Leg
Install Wheel Kit
NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 13mm wrench
• Socket wrench with a 13mm socket
• Pliers
• Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Place a wheel on each side as shown in Figure 1A.
4. Place a washer on axle and then place an e-ring in axle
groove.
Capscrew
Axle
Wheel
Hex Nut
6
A
Axle
Wheel
Flat Washer
E-Ring