Kenwood M-918DAB Operating Manual page 24

10. Service
– Never attempt to service this device yourself since if covers are opened or removed, live parts may
be exposed, touching which can be a source of risk. Please refer all servicing to qualified customer
service personnel.
11. Damage which requires repair
– Service and repair work should only be carried out by qualified customer service department.
Service/repair is required if the device is damaged (e.g. the mains cable or plug), if liquid had entered
the device, if items have penetrated into the device, if the device was exposed to rain or moisture, if it
no longer works properly or has fallen down.
12. Spare parts
– If replacement parts are needed, ensure that the customer service technician is using the
spare parts which are stipulated by the manufacturer or which have the same properties
as the original parts. Replacement parts which are not approved can lead to fire, electrical shock or
other accidents.
13. Safety check
– Please ask the customer service technician to carry out a safety check on this device after finishing
service or repair work in order to determine if the device is in proper working order.
14. Wall or ceiling mounting
-This device may only be mounted on a wall or ceiling following the manufacturer's recommendations.
15. Heat
– Do not install this device near hot surfaces such as radiators, fan heaters, ovens or other devices
(including amplifiers) which can become hot. Never place items with open flames such as candles
or lanterns on top of or near the device. The batteries which are installed should not be exposed to
great heat such as sunlight or similar.
16. Electricity lines
– An outdoor antenna should not be installed near power lines or other electrical lines or in places
where such electrical lines could fall. When installing outdoor antennas, great care should be taken
not to unintentionally touch electrical lines because that can fatal.
To minimise the risk of electrical shock, fire etc.
- Do not remove any screws, covers or housing components.
- In no position does the power switch completely disconnect the power supply.
As the mains plug is used as the disconnect device, it shall remain at the power cable and be kept
readily accessible.
4