Table of Contents
Advertisement
3. ASSEMBLING TENSION ADJUSTERS TO COVER
Nut
4. MOUNTING COVER TO SIDE RAILS
"L" Left
XT-Dial
A. The cover comes pre-rolled to
its normal open position for ease of
installation. Set pre-rolled cover on
tailgate with front bar facing up as
shown. Align XT-Dial Tension Adjuster
(marked L) on driver side of cover -
positioned as shown in photo.
B. Turn 1-1/4" bolt with flat washer
onto nut in bar. Leave loose for now.
See photo. Repeat for XT-Dial (R) on
passenger side of cover, and leave that
bolt loose also.
A. Set rolled up cover on rails at front of
box (behind cab) with bar facing up. Roll
cover bar onto front of rails and fold/tuck
vinyl flap under. Now bar will face down.
Let straps hang to inside of box. Push cover
bar forward until it sets flat on front of side
rails and overhangs them.
B. Slide left tension adjuster over until it
engages under side rail. (See photo in Step
4 E for tension adjuster tab under side rail.)
Push bar back and forth to line up holes-do
not turn dial wheel. Insert bolt from top, flat
washer and nut from bottom.
Note: These holes are designed for
a snug fit - you may need to turn the
bolt through rail and adjuster with
9/16" wrench. The bolt will thread
through without harming any pieces.
4
Advertisement
Table of Contents
