SanRex SANMIG 200MF Operator's Manual page 25

MAINTENANCE &TROUBLESHOOTING
force, welding-way, Diameter, Thickness , the Electrode and so on. When in the state of welding,
it will display the setting parameters, current voltage and current.
Setting welding current ARC force
weldway
Diameter
Thickness
electrode
Setting arc
Display the setting
force
current
The actual current and voltage display
(3) The control knob
In the process of use, this knob is mainly used for switching and confirm the page. When
shifting the button right or left, the corresponding page will jump to the right or left. When
pressing the knob, the page jump into the lower page. For example ,when in the state of MMA,
knob rotation and page jump show in the figure below.
23