Dometic MaCave S17G Operating Manual page 20

MaCave
7.3 Reversing the door
You can also change the hinge of the door, so that it opens to the left rather
than the right.
S17G and S46G
➤ Change the door as described in fig. 5, page 4 to fig. a, page 5.
➤ Fit the door handle on the other side as described in fig. h, page 6 to
fig. i, page 6.
S118G
➤ Change the door as described in fig. b, page 5 to fig. e, page 5.
➤ Fit the door handle on the other side as described in fig. h, page 6 to
fig. i, page 6.
ST 198D
➤ Change the door as described in fig. b, page 5 to fig. e, page 5.
Turn the door by 180°.
➤ Move the closing solenoid to the opposite position.
S24G
➤ Change the door as described in fig. f, page 6 to fig. g, page 6.
Turn the door by 180°.
7.4 Notes on the electrical connections
A
NOTICE!
Leave the appliance to stand upright for about 2 hours after trans-
porting, before you connect it to the power supply.
Otherwise this could cause faults in the cooling system.
Observe the following when connecting the appliance:
z Connect this appliance to a 15 A circuit.
z Check that the voltage specification on the type plate is the same as that
of the power supply.
z If you are using an extension cord, it must be suitable for the values which
correspond to the device, see chapter "Technical data" on page 57.
EN
Setting up and connecting the appliance
20