To Replace Mower Blade Drive Belt; Mower Drive Belt Removal - Husqvarna TS 348XD Instruction Manual

6
A

To Replace Mower Blade Drive Belt

MOWER DRIVE BELT REMOVAL

• Park tractor on a level surface. En gage parking brake.
• Lower attachment lift lever to its lowest position.
• Remove mandrel cover (A).
• Remove any dirt or grass clippings which may have
accumulated around mandrels and entire upper deck
surface.
• Remove spring (B) from eyebolt (C).
• Remove belt (D) from all pulleys (E).
• Remove the belt from around the electric clutch (F) on
the engine shaft.
MOWER DRIVE BELT INSTALLATION
NOTE: For ease in installing the deck belt, refer to the routing
decal on the cutting deck.
BELT ROUTING
E
C
B
F
D
E
• Place the belt around all pulleys.
• Double check belt routing to make sure it matches the
routing decal, and that the belt does not have any twist.
Correct if needed.
• Connect spring to eyebolt.
• Adjust belt tension until spring is extended to a length of
5.75" (14,6 cm).
- Loosen inner adjustment nut (G).
- Turn outer adjustment nut (H) clockwise ( ) to increase
tension, counterclockwise ( ) to decrease tension.
- Tighten inner adjustment nut securely.
H
• Replace mandrel cover (A) and secure with fasteners.
84
F
D
E
G
C
B