Husqvarna TS 348XD Instruction Manual page 73

K
T
NOTE: Depending on model, bracket (T) may be different
than shown but hole for anti-sway bar will be in same position/
location.
• Pivot the integrated washer end of anti-sway bar (S) to-
wards mower deck bracket on right side of mower. Insert
integrated washer end of bar into hole in rear mower
bracket (D). Move mower as needed to insert integrated
washer end of bar into rear mower bracket (D).
• Secure with small washer and small retainer spring as
shown.
S
T
D
• ATTACH MOWER SIDE SUSPENSION ARMS (A) TO
CHASSIS - Position hole in arm over pin (B) on outside
of tractor chassis and secure with retainer spring.
• Repeat on opposite side of tractor.
A
• ATTACH REAR LIFT LINKS (C) - Lift rear corner of
mower and position slot in link assembly over pin on
rear mower bracket (D) and secure with washer and
retainer spring.
• Repeat on opposite side of tractor.
S
B
D
•
ATTACH FRONT LINK (E) - Work from left side of tractor.
Insert threaded rod end of link assembly through front
hole in tractor suspension bracket (F).
•
Install bushing (O) and loosely install nut (P) and jam nut
(Q).
•
Insert flared ends of link (E) into slots in front mower
bracket (H).
•
Check Front-To-Back Adjustment in "TO LEVEL MOWER"
in this section.
H
•
Install belt onto electric clutch pulley (M).
M
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
•
Raise attachment lift lever to highest position.
73
6
C
F
O
P
E
Q