Table of Contents
Advertisement
6
C
D
To Remove Mower
•
Place attachment clutch in "DIS EN GAGED" position.
•
Lower attachment lift lever to its lowest position.
•
Remove mower belt from electric clutch pulley (M). See
Mower Drive Belt Removal in "TO REPLACE MOWER
BLADE DRIVE BELT" in this section.
•
Disconnect front link (E) from mower.
•
Go to either side of mower and disconnect mower
suspension arm (A) from chassis and rear lift link (C)
from rear mower bracket (D) - remove retainer springs
and washers.
•
Go to other side of mower and disconnect the suspension
arm and rear lift link.
•
Remove retainer spring (G) and washer (I) from anti-sway
bar (S).
CAUTION: After rear lift links are disconnected, the at-
tachment lift lever will be spring loaded. Have a tight grip
on lift lever when changing position of the lever.
•
Slide mower out from under right side of tractor.
S
D
I
A
M
G
To Install Mower
NOTE: Ensure tractor is on level surface and engage park ing
brake.
•
Lower attachment lift lever to its lowest position.
CAUTION: Lift lever is spring loaded. Have a tight grip on
lift lever, lower it slowly and engage in lowest position.
NOTE: Ensure mower side suspension arms (A) are pointing
forward before sliding mower under tractor.
•
Slide mower under tractor until it is centered under
tractor.
TO INSTALL ANTI-SWAY BAR (S)
K
•
From right side of mower, first insert 90° end (K) of anti-
sway bar (S) into hole in transaxle bracket (T), located
near left rear tire in front of transaxle.
NOTE: Flashlight may be helpful.
72
F
O
P
Q
E
H
B
S
Hide quick links:
Advertisement
Table of Contents
