Descaling; Cleaning - Siemens TE506 RW Series Instruction Manual

de en

Descaling

Duration: approx. 25 minutes.
Important: If there is a ilter in the water
tank (17), it needs to be removed before the
descaling programme is run.
Descale required!
If the message
pears on the display, press the
ton (13) for 3 seconds and then press the
start button (10). The descaling programme
will start.
To descale the appliance before being
prompted, press the
at least 3 seconds. Then press the
button (13) briely twice. Turn the upper
rotary knob (15) until
appears in the display. To start the descal-
ing procedure, press the start button (10).
The display will guide you through the
programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
N.B.: If the water ilter is activated, the dis-
play will prompt you to remove the ilter and
then press the start button (10) again. Re-
move the ilter now if you have not already
done so. Press the start button (10).
Fill descaler
Press start
● Pour lukewarm water into the empty wa-
ter tank (17) up to the 0,5l mark and dis-
solve 2 Siemens descaling tablets in it.
● Press the start button (10).
Place container
Press start
● Place a receptacle with a capacity of at
least 0.5 litres under the outlet (6a).
● Press the start button (10).
Descale in progress
The descaling pro gramme will now run for
about 20 minutes.
18
TE_506_509_1RW.indb 18
ap-
e
off /
but-
j
e
off / button (13) for
j
e
off /
j
Start descaling
Clean / Fill water tank
Press start
● Rinse the water tank (17) and reill it with
fresh water up to the max mark.
● Press the start button (10).
Descale in progress
The descaling pro gramme now runs for
about 3 minutes and rinses the appliance.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the ilter if one is being used. The
appliance has completed descaling and is
ready for use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust ilm
on stainless steel and must therefore be
washed out thoroughly before use.

Cleaning

Duration: approx. 10 minutes.
Clean required!
If the message
on the display, press the
for 3 seconds and then press the start but-
ton (10). The cleaning programme will start.
To clean the appliance before being prompted,
e
press the off / button (13) for at least
j
3 seconds. Then press the
ton (13) briely twice. Turn the upper rotary
Start cleaning
knob (15) until
in the display. To start the cleaning proce-
dure, press the start button (10).
The display will guide you through the
programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Cleaning in progress
The appliance rinses twice.
appears
e
off /
button (13)
j
e
off /
but-
j
appears
24.01.2013 15:55:23