Advertisement
3.
Connect the control panel to power. The LEDs on the MWA500 module should turn on.
Configuration
Before you configure the module, set the
Network registration
1.
Click the network connection icon on the PC/laptop desktop.
2.
In the popup window, click
make sure the module is up and running.
3.
Enter 12345678 in the password window and click
Module settings
1.
Open a web browser, type the IP address 192.168.16.254 (the module's default address) and press
2.
In the login window that opens up, enter
3.
In the module's setting window, on the left pane, click
Disable
4.
Select
for
5.
Change the default username and password:
Administration
a.
Click
Management
b.
Click
Account
c.
In the
d.
Enter a new password in the
Apply
e.
Click
erial2Net Settings
6.
Click S
No. Field
1
NetMode
2
SSID (Wifi only)
3
Encrypt Type (Wifi only)
4
Password (Wifi only)
5
IP Type
6
Serial Configure
7
Serial Framing Length
8
Serial Framing Timeout
9
Network Mode
10
Remote Server Domain/IP
Figure 2.
Account ID
HI-LINK
and click
TCP Client Auto Check
on the left pane.
.
Administrator Settings
field, under
Password
; you will now have to re-enter the settings window with the new definitions.
on the left pane and set the parameters, described in the table below.
Setting
Select WIFI(CLIENT)-SERIAL for Wifi mode.
Select
Enter the network SSID, or press
network list.
WPA2 AES
The router's password.
DHCP
2400,8,n,1
256
2000
Client
force.pimalink.com
Installation diagram
of partition #1 in the control panel to '0001'.
Connect
HI-LINK
. If
Connect
.
admin
as user name and as password, and click
Advance Settings
.
, enter a new user name.
field.
ETH-SERIAL
for Ethernet mode.
MWA500
SERIAL
Connector
Control Panel
is not on the available connection list,
.
Scan
and select the router from the
Configuration
Enter
.
Log in
.
3
Advertisement
