Advertisement
MWA500 Wi-Fi & Ethernet Module Installation Guide
Introduction
This guide will help you through the installation and configuration of the MWA500 wi-fi and Ethernet module. It
allows users of the Hunter-Pro Series and Captain 8 intruder alarm systems, to use the PIMAlink 3.0 app and
cloud service. The module is based on Hi-Link (www.hlktech.net) product.
The MWA500 is configured through a web browser.
Features
Multiple Wi-fi standards support
Ethernet connection
Mounted in the enclosure of the control panel
Easy web browser configuration
Content of the product package
MWA500 module, mounted on a bracket.
Technical specifications
Network Standard:
Transmission Rate:
Frequency Range:
Interface:
Antenna:
Temperature:
Humidity:
Quick Reference Guide
The LEDs
Label + color
Indication
Power, red
Voltage OK
LAN, green
LNA connection OK
Wifi, Green
Wifi connection OK
Installation
Disconnect the control panel from AC and battery power prior
to installation.
Do not touch the antenna's wire connecter.
1.
Pass the antenna through the hole on the top side of the control panel's enclosure, from inside out, and
fasten the module with the two supplied screws. If a radio transmitter or a cellular module are installed,
break one of the knockouts.
2.
Connect the wire harness between the module and the SERIAL (J4) connector on the control panel.
2
Wireless: IEEE 802.11n, IEEE 802.11g, IEEE 802.11b
Ethernet: IEEE 802.3, IEEE 802.3u
11n: maximum up to 150Mbps
11g: maximum up to 54Mbps
11b: maximum up to 11Mbps
2.4 - 2.4835GH
10/100Mbps, LAN/WAN, Multiplex
External
-10 to +50
O
C
90%, non-condensed
Antenna
Screws
Reset button
Figure 1. The MWA500 module
This guide
To SERIAL
Connector
LEDs
Not in use
Ethernet socket
Advertisement
