Download Print this page
Pima GSM501 Installation Instructions
Pima GSM501 Installation Instructions

Pima GSM501 Installation Instructions

Advertisement

Available languages

Available languages

Quick Links

GSM501
Installation Instructions
Инструкция по установке
‫הוראות התקנה‬
English, Русский, ‫עברית‬
1
3
5
4
6
7
GSM501 Cellular Add-on
GSM501 is a Quad-band, single SIM, GSM/GPRS add-on that allows the connection of the FORCE alarm system to a cellular network.
The add-on is mounted on the control panel's circuit board and is supplied with an antenna.
The GSM501 is supplied without a SIM card. Only cards with no PIN lock can be used.
For the add-on configuration information, see the FORCE's Installation guide (P/N: 4410459).
Technical specifications
Channels: GPRS/SMS/Voice
Quad-band: 850/900/1800/1900MHz
Sizes: 9 X 7 X 2.5cm
Antenna Cable Length: 2m
Content of the product package
GSM501 cellular add-on
How to install the GSM501
Disconnect from AC and battery power before installing the GSM501.
Follow the next steps to install the add-on.
1.
Carefully push the SIM card into the card holder (no. 7 on the figure above), with the metal contacts facing down, and the angled
corner of the card positioned correctly.
2.
Connect the antenna to the add-on, by rotating the SMA connector clockwise.
3.
Pressing gently, connect the add-on to the onboard circuit board connector (no. 8 on the figure above).
4.
Connect the control panel to power.
5.
Set the add-on in the control panel; see the FORCE's Installation guide for details.
6.
Locate the antenna where the cellular network signal is strong.
7.
Test the add-on.
2
8
Antenna + cable
1
Antenna (SMA)
2
GSM501 Transceiver
3
FORCE's Control Panel
4
Antenna Base
5
Network LED
6
Power LED
7
SIM Card Holder
8
Circuit Board Connector
Current Consumption: Min.-30mA, Max.-200mA
Weight: 335gr
CE Compliance
Operating Temperature: °C -10 to +55
Humidity (Max.): 93% R.H., Non-condensing.
This guide
-1-
1
Антенна (SMA)
2
GSM модуль GSM501
3
Контрольная панель FORCE
4
Коннектор антенны типа SMA
5
Светодиод «Сеть»
6
Светодиод «Питание»
7
Держатель SIM-карты
8
Разъем подключения к
контрольной панели
(SMA)
GSM501
‫לוח הבקרה של‬
FORCE
‫בסיס אנטנה‬
‫נורית רשת‬
‫נורית מתח‬
‫תושבת כרטיס סים‬
‫כרטיס לוח הבקרה‬
‫אנטנה‬
1
‫מודול‬
2
3
4
5
6
7
‫בר‬
‫מח‬
8

Advertisement

loading
Need help?

Need help?

Do you have a question about the GSM501 and is the answer not in the manual?

Questions and answers

Summary of Contents for Pima GSM501

  • Page 1 GSM501 Cellular Add-on GSM501 is a Quad-band, single SIM, GSM/GPRS add-on that allows the connection of the FORCE alarm system to a cellular network. The add-on is mounted on the control panel’s circuit board and is supplied with an antenna.
  • Page 2 The LEDs The GSM501 has two LEDs: network registration and voltage. The LEDs states are described Below. State Description Network Flashes rapidly Initializing Registration (Red) Flashes once every 3 sec. Modem registered Flashes once every 1 sec. Modem not registered...
  • Page 3 GSM501 ‫סלולרי‬ ‫תאם‬ ‫מ‬ ‫המודול‬ ‫לרשת סלולרית‬ ‫האזעקה‬ ‫מערכת‬ ‫, המאפשר לחבר את‬ Quad-band ( ‫ארבעה תדרים‬ GSM/GPRS ‫תאם סלולרי‬ ‫הינו מ‬ GSM501 FORCE .‫מותקן על כרטיס לוח הבקרה, והוא מסופק עם אנטנה‬ ‫נעילה‬ ‫לא ניתן להשתמש בכרטיס סים עם קוד‬...
  • Page 4 Limited Warranty PIMA Electronic Systems Ltd. does not represent that its product may not be compromised and/or circumvented, or that the Product will prevent any death, personal and/or bodily injury and/or damage to property resulting from burglary, robbery, fire or otherwise, or that the Product will in all cases provide adequate warning or protection.