Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Stanley FATMAX KFFMEG220
Summary of Contents for Stanley FATMAX KFFMEG220
- Page 1 KFFMEG220...
-
Page 4: Intended Use
If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) Your Stanley Fat Max KFFMEG220 angle grinders have been protected supply. Use of an RCD reduces the risk of designed for grinding and cutting metal and masonry using the electric shock. - Page 5 (Original instructions) ENGLISH d. Store idle power tools out of the reach of children and For accessories mounted by flanges, the arbour hole do not allow persons unfamiliar with the power tool or of the accessory must fit the these instructions to operate the power tool. Power locating diameter of the flange.
-
Page 6: Kickback And Related Warnings
ENGLISH (Original instructions) Safety warnings specific for grinding and abrasive Regularly clean the power tool's air vents. The motor's cutting-off operations fan will draw the dust inside the housing and excessive accumulation of powdered metal may cause electrical Use only wheel types that are recommended for your hazards. -
Page 7: Safety Warnings Specific For Sanding Operations
If the supply cord is damaged, it must be replaced by the risks can not be avoided. These include: manufacturer or an authorised Stanley Fat Max Service Injuries caused by touching any rotating/moving parts. Centre in order to avoid a hazard. - Page 8 (12) using the two-pin spanner (13) (fig. D). (for 115mm cutting wheel) and N542445 (for 125mm cutting Remove the outer flange (12) and the disc (10). wheel) are available and can be obtained from Stanley Fat Fitting Max service centres.
- Page 9 For sanding, a backing pad is required. The backing pad is Maintain a 5˚ to 10˚ angle between the tool and work available from your Stanley Fat Max dealer as an accessory. surface as shown in figure H. The sanding disc should contact approximately 25mm of work surface.
- Page 10 ENGLISH (Original instructions) NO EATING, DRINKING or SMOKING should be done Maintain contact between the edge of the wheel and the in the work area to prevent ingesting contaminated work surface with wire wheels. paint particles. Workers should wash and clean up Continuously move the tool in a forward and back motion BEFORE eating, drinking or smoking.
-
Page 11: Troubleshooting
When grinding, always maintain an angle of approx. 15° between the disc and the workpiece surface. Maintenance Your Stanley Fat Max corded/cordless appliance/tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. - Page 12 ENGLISH (Original instructions) Grinding and cutting accessory chart 125mm Type 41 Cutting Wheels 125mm Grinding Wheels Type 41 guard Type 41 guard Type 27 guard Type 27 guard Backing flange Backing flange Unthreaded backing flange Abrasive cutting wheel Diamond cutting wheel Type 27 depressed center Type 27 hubbed wheel wheel...
-
Page 13: Protecting The Environment
Technical data Guarantee KFFMEG220 Stanley Fat Max is confident of the quality of its products and Input voltage offers consumers a 12 month guarantee from the date of purchase. This guarantee is in addition to and in no way Power input prejudices your statutory rights. - Page 14 ENGLISH (Original instructions)
- Page 15 (Original instructions) ENGLISH...
- Page 16 United Kingdom Stanley Fat Max Tel. 01753 511234 210 Bath Road Fax 01753 572112 Slough, Berkshire SL1 3YD www.stanleytools.co.uk N606235 REV-0 06/2018...
Need help?
Do you have a question about the FATMAX KFFMEG220 and is the answer not in the manual?
Questions and answers