Filtec Omnivision 1000 Series Upgrade Installation Manual page 11

Installation Overview
Document 45277-0805
In Inspection Head
• All optics/cameras (remove Servo Adapter from base)
• Trigger blocks and terminal strip
• Finish Strobe
• Servo Control card Mounting plate (if parts exists)
In Base Cabinet:
• Wiring troughs
• All Base Strobe transformer and rectifier parts (Remove
strobe unit for re-installation later)
• All Finish Strobe transformer and rectifier parts
• Water valve
• Master Air Valve
• Starwheel motor
• Clutch/Brake(s)
• Starwheel Encoder
• AC Filter
• Transformer T1 & T2
• IDC-supplied Sola power regulator (if exists)
• TB1 and all wiring to Vacuum motor starter and trans-
former primaries
• Wiring between vacuum motor starter and vacuum motor
• Vacuum Pump
• All vacuum/reject and air components/hoses
• Base Cabinet fan
• Diffuser/Brush Drive system
All harnessing is removed from the machine and the existing
electronics removed and prepared to be shipped back to the
factory.
The only wiring that will be re-used for the installation are the AC
wires that go to the utility outlets in the upper cabinet and the
monitor enclosure as indicated above.
Drilling on the OV should be done before insertion of the new
harness to prevent any damage to the wires.
3