Subscribe to Our Youtube Channel
Related Manuals for Lumencor PEKA
Summary of Contents for Lumencor PEKA
- Page 1 PEKA Light Engine Instruction Manual umencor, Inc. Document 57-10004 www.Lumencor.com...
- Page 2 Lumencor utilizes regulatory model names for all certified and CE marked products. The regulatory model names are traceable to all regulatory documentation, third party reports and certifications. “Regulatory Model: Peka” is used as a representative model for all certified and CE marked Peka Products. Emissions This equipment has been tested and found to comply with the limits of EMC directive 2014/30/EU.
-
Page 3: Table Of Contents
" Table of Contents Introduction Precautions and Warnings Installation and Operating Instructions Spectral Output Product Specifications Routine Maintenance and Troubleshooting Customer Support Warranty PEKA Light Engine Instruction Manual... -
Page 4: Introduction
PEKA light engine is completely quiet and vibration free. The PEKA light engine is manually controlled via knobs located on the side panel of the light engine or on the base of Nikon microscope stands. Additionally, the light output can be electronically gated off and on by TTL signals applied to a BNC connector on the rear panel. - Page 5 Warning: DO NOT use an unapproved power supply. The Lumencor supplied 9V, 4.45A external power supply is required for use with the Peka light engine. It is imperative that the alternative power supply has output over-current protection, as the power input of the Peka is not fused. The DC power supply must have the AC power cord connected to a receptacle with a protective safety (earth) ground terminal.
- Page 6 DISCLAIMER: Lumencor shall not be liable for injury to the user or damage to the product resulting from the PEKA light engine being used in a way for which it was not intended and in complete disregard for all posted safety precautions and warnings.
- Page 7 Figure 1. PEKA light engine with output adapter for coupling to Nikon Ti/Ni/Ci micro- the high intensity light when turning on the unit. The PEKA light scope transmitted light port. engine should be coupled to a microscope before it is turned on.
- Page 8 Nikon microscope base. stand using the Nikon DIA LAMP control cable. Turn the POWER knob on the PEKA to the on position. Light on/off status and intensity can then be controlled by the push button and rotary dial located next to the focus knob on the Nikon microscope base (Figure 4).
-
Page 9: Spectral Output
" 4. Spectral Output The typical spectral output distribution of a PEKA light engine is shown below (Figure 5). Figure 5. PEKA Light Engine spectral output distribution. PEKA Light Engine Instruction Manual... -
Page 10: Product Specifications
In the event that the light engine is sold, the certificate of conformance should be transferred to the new owner. Certificates of conformance are also recorded in Lumencor’s database and copies can be requested by e-mail to techsupport@lumencor.com. The request message must include the 4- or 5-digit serial number of the light engine. -
Page 11: Customer Support
RMA number. 8. Warranty The PEKA light engine is backed by a 18 month warranty to end users. Warranty coverage starts on the original date of shipment from Lumencor. Light Engines qualifying for warranty service must be verifiably delivering perfor- mance that is substantially at variance with the levels documented in the certificate of conformance.
Need help?
Do you have a question about the PEKA and is the answer not in the manual?
Questions and answers