Table of Contents
Advertisement
PRESET 1 – 5 - Hold (approximately 5 seconds) to save & store the current pressure settings to the desired preset.
1.
2.
MENU- Press to display Menu Options. If in Menu Options, pressing Menu will take operator back one screen and
eventually to operating screen.
3.
ENTER- Press to activate/deactivate the system, also used in Menu options to make selections.
4.
POWER- Press and hold (approximately 7 seconds) to turn ON/OFF the 2940-100 Cab Controller Display.
5.
UP I-IV- Press I to raise all row cleaners max travel. Pressing again lowers all row cleaners to preset setting. Up II-IV
are not used!
6. A
PSI UP Encoder(RU) - rotate to INCREASE/DECREASE Air Pressure on the attachment.
PSI DOWN Encoder (RD) - Rotate to INCREASE/DECREASE Air Pressure on the attachment.
6. B
PSI Aux Encoder (WT, A1, A2, A3) - Push to scroll the curser. ROTATE to INCREASE/DECREASE air pressure on
the curser selected circuit. (WT, A1, A2, and A3) WT circuit is the only circuit used. A1, A2, & A3 are not utilized at
this time.
7.
Push to scroll DOWN in the MENU display
dump the water separator. Valve remains open for as long as button is pressed.
8.
Push to scroll UP in the MENU display.
38
Cab Controller Operation
.
Hold this down for 10 seconds to manually
Advertisement
Table of Contents
