Table Of Contents - Yetter AIR ADJUST 2940 Operator's Manual

Bolt Torque............................................................................................2
Safety...................................................................................................4
2940 Components, Kits, Accessories, and Ordering Part Numbers................. 5-9
Introduction & System Requirements.........................................................10
System Information............................................................................11-14
Installation Instructions....................................................................................15-37
Operation.........................................................................................38-44
Maintenance.....................................................................................45-47
Parts Identification..............................................................................47-61
Troubleshooting......................................................................................62
Notes.......................................................................................................................63
Mounting bolts and hardware
All hardware used on the 2940 Air Adjust is Grade 5 unless otherwise noted. Grade 5 cap screws are marked with three radial
lines on the head. If hardware must be replaced, be sure to replace it with hardware of equal size, strength and thread type.
Refer to the torque values chart when tightening hardware.
Important: Over tightening hardware can cause as much damage as when under tightening. Tightening hardware
beyond the recommended range can reduce its shock load capacity.
The chart below is a guide for proper torque. Use it unless a specified torque is called out elsewhere in the manual.
Torque is the force you apply to the wrench handle or the cheater bar, times the length of the handle or bar. Use a
torque wrench whenever possible.
The following table shows torque in ft. lbs. for coarse thread hardware.
2

TABLE OF CONTENTS

Installation Guide..........................................................15
Residue Manager/RM Coulter Combo....................16-19
Cab Controller...............................................................20
Compressor ..................................................................21
Control Box ...................................................................22
Compressor & Control Box Cable/Harnesses.......23-24
Dump Valve Assembly..................................................24
Airline Routing...............................................................25
Airline & Dump Valve Diagrams..............................26-37
BOLT TORQUE