Table of Contents
Advertisement
Electric Communication Harness
(Only if application is using the Yetter Electric Compressor)
Step 1: Install the 2940-181 hydraulic compressor solenoid/switch harness; the male 2 pin connector installs into the female connector on the
On/Off solenoid on the hydraulic block on the side of the compressor housing, the female 2 pin connector installs into the male 2 pin connector on
the pressure switch.
Step 2: Connect the 2940-189 10 foot control harness to the 4 pin connector of the 2940-181 & route to control box. If more length is needed, call
Yetter & order more. (2940-182 is 20 foot length; 2940-189 is 10 foot length)
Step 3: Connect the 2940-182 or 2940-189 into the 4 pin female connector on the side of the control box.
2940 -136 Dump Valve Kit Installation
Step 1 - Align the holes on valve (8) with mounting plate (3) holes. Insert bolts (5) through the aligned holes and start the nuts (4)
on the threads. Tighten nut with ¼" wrench while holding bolt with a Phillips screwdriver until tight.
Step 2 - Install supplied 6" piece of airline (6) in port 1, the vent elbow (7).
Step 3 - If install is on a John Deere planter, use flat flanged nut (1) to install Dump Valve assembly by placing circle cut out on mounting tab (3) on
U-bolt used to mount the row unit to planter toolbar. Pinch mounting tab (3) between existing nut on U-bolt & the flat flanged nut (1). If install is on
any other OEM planter, use the serrated flanged nut (2) for the install of the dump valves.
Solenoid Down
Solenoid Up
Single Dump Valve Mounting
Dual Dump Valve Mounting
See pages 26 – 36 for dump valve & dump valve harness installation. Dump valve placement will vary depending on planter size. Dump valve cable
length will vary depending on planter model & row spacing. White dump valve cables are to be used on all lift circuit (blue airline) dump valves.
Black dump valve cables are to be used on all down pressure (black airline) dump valves.
24
Advertisement
Table of Contents
