Electrolux EWW8023AEWA User Manual page 14

14 www.electrolux.com
●
No Spin (
No spin option eliminates all the spin
phases and increase the number of
rinses.
●
Rinse Hold (
By selecting this option the water of
the last rinse is not emptied out and
the drum turns regularly to prevent the
laundry creases.
The door is still locked to indicate that
the water must be emptied out.
Vapour (
Select this option to add approximately
30 minutes of tumbling in vapour during
the wash cycle. Vapour helps open fabric
fibers up to allow laundry additives to
release tough stains. The indicator of this
option will be on.
●
Vapour may not necessarily be visible
inside the drum during a vapour wash
cycle. Vapour is created below the
drum and allowed to naturally rise into
the clothes.
●
Vapour may not be present during the
entire vapour wash cycle.
●
Vapour function is more effective with
half load.
●
At the end of the Vapour cycle, the
clothes will be warmer, softer and
detached from the drum.
If Vapour option is selected, rinse
temperatures will be elevated.
During a vapour cycle, you may notice
vapour exiting from the drain hose of
the Wahser-Dryer, this is normal and
there is no cause for alarm.
)
)
The door stays locked with the
water in the drum. To continue
the cycle, you must press
(Start/Pause).
) Touchpad
NOTE
Prewash Touchpad
Select this option if you wish your laundry
to be pre-washed before the main wash.
Use this option for heavy soil. The
indicator of this option will be on.
When you set this function, put the
detergent into the "
This function increases the program
duration.
Extra Rinse Touchpad
This option is recommended for people
who are allergic to detergents, and in
areas where the water is very soft.
Press this touchpad to add two rinse
phases to a program. The indicator of
this option will be on.
Delay Start Touchpad
This option makes it possible to delay the
start of the program by 30 min, 60 min or
90 min and then by every hour from 2 to
20 hours.
The delay you have selected is indicated
on the display. The end time will increase
in order to show you the selected delay.
You must select this option after you have
set the program and before you press the
Start/Pause button.
If you wish to add laundry in the machine
during the delay time, press Start/Pause
touchpad to put the machine in pause
mode. Add laundry, close the door and
press Start/Pause touchpad again.
You can cancel the delay time at any
moment, by pressing "Delay Start"
touchpad repeatedly till the display shows
delay time " ", then press the
Start/Pause touchpad.
" compartment.