Sony PMW-10MD Instructions Before Use page 19

For the customers in Canada
CAN ICES-3 (A)/NMB-3(A)
For the customers in Canada
This unit has been certified according to
Standard CAN/CSA-C22.2 No.60601-1.
For the customers in the U.S.A and Canada
When you use this product connected to
240 V single phase, be sure to connect this
product to a center tapped circuit.
Important safeguards/notices for use in the
medical environments
1. All the equipments connected to this unit
shall be certified according to Standard
IEC 60601-1, IEC 60950-1, IEC 60065
or other IEC/ISO Standards applicable to
the equipments.
2. Furthermore all configurations shall
comply with the system standard
IEC 60601-1. Everybody who connects
additional equipment to the signal input
part or signal output part configures a
medical system, and is therefore,
responsible that the system complies
with the requirements of the system
standard IEC 60601-1.
If in doubt, consult the qualified service
personnel.
3. The leakage current could increase
when connected to other equipment.
4. For this particular equipment, all
accessory equipment connected as
noted above, must be connected to
mains via an additional isolation
transformer conforming with the
construction requirements of IEC 60601-
1 and providing at least Basic Insulation.
5. This equipment generates, uses, and
can radiate radio frequency energy. If it is
not installed and used in accordance with
the instruction manual, it may cause
interference to other equipment. If this
unit causes interference (which can be
determined by unplugging the power
cord from the unit), try these measures:
Relocate the unit with respect to the
susceptible equipment. Plug this unit and
the susceptible equipment into different
branch circuit.
Consult your dealer. (According to standard
IEC 60601-1-2 and CISPR11, Class B,
Group 1)
19