BioEnergiser circulation maxx reviver Instruction Manual page 9

FOR BOD Y
Using The Gel Pads
Wash and dry skin before use. Connect the output wire
to the gel pads. Connect the other end of the output
wire to the output jack on Circulation Reviver
the protective film from the adhesive pads. Attach the
gel pads to the skin. Press the on/off button to turn on
the unit and adjust the stimulating output intensity to
the desired level. (The display will show the mode and
level that you selected and start to count down).
1. Plug in the 2 cable into the cable jack on the unit.
(see Fig. 5)
2. Connect pin of the cable to the gel pad properly.
(see Fig.6)
3. Remove the protective film on the gel pad, and
attached the 4 gel pads to the area of the body you wish
to treat.
4. Repeat operation as in foot instructions, adjust the
intensity using for body .you wish to treat.
5. Gently increase intensity setting by pushing the
button of "Body + ". Or decrease intensity setting by
pushing the button of "Body - ". The LCD will also show
the level which you have selected (see Fig. 7).
6. To terminate the massage period, user can turn off the
unit anytime by pressing the on/off Button.
Care Of Your Gel Pads
Never stick two adhesive pads to each other. Keep the
adhesive gel pads clean, never expose them to high
temperature or direct sunshine. If the electrode gel pads
are insufficiently adhesive or dirty, wipe with a wet cloth
or change for new ones, replacement parts will be
available directly from BioEnergiser or your distributor.
Do not clean the electrode gel pads with any
chemical.
ALWAYS try and protect the gel pads. Store the gel pads
on the gel pad protector when not in use, as in the
illustration.
For more information about BioEngergiser Products visit our website at: www.globalproductcom
. Remove
TM
Fig.5
Fig. 7
9
A B
Fig. 6
7