Troubleshooting
Please check following points before arranging for service.
Problem
The appliance does
● Is the power plug inserted into an outlet?
not run after the
► Insert the power plug into an outlet.
switch is turned on.
● The circuit breaker protection is activated.
• You have used prohibited ingredients.
The appliance
• The volume of ingredients is too large.
stopped suddenly.
• The ingredients are too hard.
► See "Circuit Breaker Protection" (See P.EN15).
The switch does not
turn.
The LED light is not
on even the
appliance is in use.
(Only MK-ZJ3500)
● This is a malfunction.
► Please contact the service center for repair.
The LED light is on
but the appliance
does not start.
(Only MK-ZJ3500)
The feed screw is
not turning even the
motor is on.
EN14
Cause and Action
Circuit Breaker Protection
When the circuit breaker automatically stops motor due to overloading, follow the below steps.
1
Switch off, then push in and turn the switch to "Reverse" for a few seconds.
(Do not turn it more than 5 seconds.)
Circuit breaker is reset during turn the switch to "Reverse".
2
Unplug and detach the parts by reversing steps on "To Grind Meat" from 3-5 to remove
ingredients in the head.
3
Attach the parts again and continue grinding meat.
Note:
• Circuit breaker may not reset over 40 °C room temperature. In that case please move
appliance to the room temperature under 35 °C and wait it is cooled down.
Specifications
MK-ZJ3500
Power supply
Power consumption
430 - 530 W
Dimensions (W × D × H)
(approx.)
Weight (approx.)
Attachments
Cutting plates, Kubbe attachments, Sausage attachment, Cleaning tool
MK-ZJ2700
220 - 240 V
50 - 60 Hz
400 - 500 W
19.5 x 43.7 x 44.0 cm
7.5 kg
EN15