Advertisement
3 individual customized load management receptacles can be individually powered off and back on again via software interface to reboot
remote equipment or perform "load shedding" of less critical loads to extend battery runtime for the most critical equipment
Built-in Emergency Power Off (EPO) interface supports emergency shutoff in large facilities
Hot-swappable/user replaceable batteries allow on-site battery replacement without powering off connected equipment
UPS battery set ships fully assembled and ready for use, no time consuming, connection of individual internal batteries by user is necessary
Specifications
OUTPUT
Output Volt Amp Capacity
(VA)
Output kVA capacity (kVA)
Output Watt Capacity
(watts)
Output kW capacity
Output power factor
Nominal Output Voltage(s)
Supported
Frequency compatibility
Output voltage regulation
(line mode)
Output voltage regulation
(Battery mode)
Built-in UPS output
receptacles
Built-in controllable
switched load banks
Output circuit breaker
Output AC waveform (AC
mode)
Output AC waveform
(battery mode)
INPUT
Rated input current (at
maximum load)
Nominal Input Voltage(s)
Supported
UPS input connection type
Input circuit breaker
UPS Input cord length (ft.)
UPS Input cord length (m)
Recommended Electrical
Service
BATTERY
Full load runtime (minutes)
3000
3
2250
2.2
0.8
120V
60 Hz
-18% / +8%
+/- 5%
7 5-15R outlet(s); 2 5-15/20R outlet(s); 1 L5-30R outlet(s)
Three switchable two-outlet 5-15R load banks
20A branch rated (x2) - breaker 1 protects 5-20R, breaker 2 protects 5-15R, L5-30R is unbreakered
Sine wave
PWM sine wave
24A
120V AC
L5-30P
30A
8
2.4
120V 30A
4 min. (2250w)
Advertisement
