Led Flashlight; Auto Shut-Off Feature - Motomaster 011-2062-4 Product Manual

10
model no.011-2062-4
LED Status
Good Connection
Reverse Connection
IMPORTANT INFORMATION
This unit has an OVERRIDE feature, which allows you to force
'ON' the jump start function to allow you to boost 12V
batteries down to 0 Volts. There are two cases where you
may be required to use this mode:
Note: the OVERRIDE mode will only be active for 30 seconds. Once 30 seconds
has passed, the unit will reset.
contact us 1 888 942-6686
Action
Proceed with jump start attempt
Reverse clamp connections.
Once the LED is solid green,
proceed with jump start attempt.
Press the OVERRIDE button.
Once the LED is solid green, proceed
with jump start attempt within 30 seconds
Check to ensure clean and solid connection
between clamps and battery terminals.
(If both LEDs are still off, the unit can not
detect a battery)
ENSURE CORRECT POLARITY (red clamps
to POS + terminal of the battery and black
clamp to the NEG – terminal of the battery).
Press the OVERRIDE button
Once the LED is solid green, proceed
with jump start attempt within 30 seconds
CAUTION! USE THE OVERRIDE MODE WITH EXTREME CARE.
This mode is for 12 volt lead-acid batteries only.
Both the spark proof and reverse polarity protection feature are disabled.
Pay very close attention to the polarity of the battery before using this mode.
DO NOT allow the positive and negative battery clamps to touch or connect to
each other as the product will generate sparks.
This mode uses very high current (up to 600 Amps) that can cause sparks and
high heat if not used properly.
If you are unsure about using this mode, do not attempt and seek professional help.

LED Flashlight

This unit has a built-in multi-mode LED flashlight for convenience and emergency use.
Hold the button for 3 seconds to activate the LED flashlight. Keep pressing
the button to cycle through the 4 options.
100% -> Strobe -> SOS - > Off

Auto Shut-Off Feature

This jump starter has a built-in energy saving feature that will automatically shut
off the unit after 30 seconds if no load is detected.
11