Advertisement
SECURE TOILET
Assemble bolt cap bases, washers, and nuts on exposed
T-bolts.
CAUTION: Risk of personal injury or product
damage. Over-tightening may cause breakage or
chipping.
Hand-tighten nuts, then tighten an additional 1/2-turn with
wrench. If T-bolts extend more than 1/4" from top of nut,
cut off excess with a hacksaw and file cut edges. Wipe
away any residue. Install bolt caps.
TO INSTALL NEW TANK
Unscrew the pushbutton and remove the tank lid.
Remove bags located in the tank. Assemble tank gasket
into place and lower the tank onto the base, carefully
aligning the holes on tank and base.
Insert rubber washers, washers, and screws inside the
tank. Make sure the tank screws extend through the holes
in the toilet base.
Assemble the brass washers and nuts to the screws from
uinder the tank.
CAUTION: Risk of personal injury or product
damage. Overtightening may cause breakage or
chipping.
INSTALL SEAT
Place rubber washers on the seat hinges and position in
holes located on toilet base. Tighten nylon nuts onto seat
hinges extending through bottom of bowl.
AA
112363–2–
(0793)
Bolt Cap
Nut
Washer
Bolt Cap Base
Push Button
Tank Lid
Nut
Rubber
Washer
Tank Gasket
Washer
Screw
4
Fig. #7
Fig. #8
Kohler Co., Kohler, WI
Advertisement
