Operation; Commissioning (Incl. Pairing); Connection Test; Comfort Programs - Smart Start/Stop Mode - Rehau NEA SMART R Installation And Operating Manual

4.2

Operation

The room control display can be operated via the control knob:
Pressing the control knob activates menus and functions.
Rotating allows setting the target temperature as well as
- +
navigating between menus and functions.
A basic level and three menus are available.
Basic level:
Rotating sets the desired target temperature.
- +
Menu selection with:
Functions: includes all important lifestyle functions.
Parameters: includes several parameters e. g. heating and
setback temperatures, date and many more.
Service: includes settings for the specialist (secured by PIN,
see manual of the base station)
4.3

Commissioning (incl. pairing)

1. No other base stations within range must be in pairing mode.
2. Activate the pairing function at the base station for the desired
heating zone (see manual NEA Smart R base station 230 V).
3. Press the control knob for approx. 3 secs. in order to activate
pairing function (the display shows "Set").
- The base station and the room control unit D are now con-
nected to each other.
- If the base station has been programmed before, the date and
time of the room control unit are set automatically.
For first commissioning of the base station:
Set year, date and time by rotating, confirm entries by pressing the
control knob.
4.4

Connection test

Press the control knob for approx. 3 secs. in order to activate pairing
function (the display shows "Set").
At the base station, the heating zone connected to this room control
unit changes status for 1 minute, in other words switches on or off
depending on the previous operating status.
8
4.5

Comfort programs - Smart Start/Stop mode

Comfort programs include pre-defined heating times to be used for
week days (1-5) or for weekends (6-7). Outside the heating times the
installation switches to night mode. You can select the comfort
programs in the Parameter menu. The Smart Start/Stop Mode of the
system calculates the required times in order to achieve the desired
temperature at the start and finish time of the heating program.
Program Comfort time 1
P0 05:30 – 21:00
P1 04:30 – 08:30
P2 06:30 – 10:00
P3 07:30 – 17:30
Tab. 4-2 Predefined time programs
You can create individual comfort programs with the on-line software
available under www.ezr-home.de and transfer these to the base
station with a MicroSD card.
4.6

Lifestyle functions overview

In this menu you can activate or deactivate the lifestyle functions.
1. Press the control knob.
2. Activate the menu "Lifestyle functions" by pressing the control
knob again.
3. Select the desired lifestyle function.
The following lifestyle functions are available to you; you can find
further information in the Table 4-3 (page 9).
It may take up to 10 minutes before changes of global lifestyle
functions are displayed on all room control units.
–
Fig. 4-2 Selection menu of lifestyle-functions
Comfort time 2
–
17:30 – 21:30
18:00 – 22:00
–
+