BMW Motorrad R 1250RT Rider's Manual page 42

Hide thumbs Also See for R 1250RT:
Table of Contents

Advertisement

3
TPC/RDC sensor is not
active
40
min 19 mph (min 30 km/h)
(The TPC/RDC sensor does
not transmit a signal to the
motorcycle until this minimum
speed has been exceeded.)
Watch the TPC/RDC display
at higher speed. A continuous
error is only present if the gen-
z
eral warning lamp also lights
up. In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Possible cause:
There is a fault in the radio con-
nection to the TPC/RDC sensors.
Possible causes are radio sys-
tems in the surrounding area,
which interfere with the connec-
tion between the TPC/RDC con-
trol unit and the sensors.
Observe the TPC/RDC display
in a different environment. A
continuous error is only present
if the general warning lamp
also lights up. In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Battery of the tire
pressure sensor weak
with tire pressure monitor
OE
(TPM)
shows yellow.
appears on the display.
NOTICE
This fault message is only shown
for a short time immediately fol-
lowing the Pre-Ride-Check.
Possible cause:
The battery for the tire inflation
pressure sensor is no longer
charged to full capacity. Oper-
ation of the tire inflation pressure
control is only ensured for a lim-
ited time.
Contact an authorized service
facility, preferably an authorized
BMW Motorrad retailer.
ABS self-diagnosis
routine not completed
flashes.

Advertisement

Table of Contents
loading

Table of Contents