Coil Surface Unit Module - GE JSP69 Use And Care And Installation Manual

How to Insert the Module
1. Be sure the controls are turned to OFF. To install
the module, position the electrical plug to face
the rear wall of the cooktop opening. There you
will see the electrical receptacle. (A receptacle is
available in either cooktop opening.) Let the
leading corners of the module rest on the cooktop
surface.
2. Carefully slide the module plug toward the
receptacle until plug is engaged completely
in receptacle. Allow the module to fit into the
cooktop opening.
3. Lower the inside edge of the module into
the cooktop opening until it is flush with the
cooking surface.
How to Remove the Module
Be sure the entire module surface is cool before
attempting to remove the module. The coils of the
module will retain heat after the controls have been
turned off. Be careful not to get burned on a module
that has not had sufficient time to cool after use.
Cookware
Use medium- or heavy-weight cookware. Aluminum
cookware conducts heat faster than other metals.
Cast-iron and coated cast-iron cookware are slow to
absorb heat, but generally cook evenly at low to
medium heat settings. Steel pans may cook unevenly
if not combined with other metals.
For best cooking results pans should be flat on the
bottom. Match the size of the saucepan to the size of
the surface unit. The pan should not extend over the
edge of the surface unit more than one inch.
Always read and follow the cookware manufacturer's
instructions on cookware use.
12

COIL SURFACE UNIT MODULE

1. Lift the finger tab at the outside edge of the module
until the module base clears the cooktop opening.
2. Hold the module by the front edges. Carefully pull
the module forward until the module plug is
disengaged from the receptacle.
Right
Not over 1 inch
Wrong
Over 1 inch