Summary Of Configuration Parameters - Wachendorff UR3274 Series Manual

14 Summary of Configuration
parameters
Date:
Installer:
Notes:
Command output type selection
c.out
Analog input configuration
sen.
Number of decimal points
d.p.
Lower limit setpoint
Lo.L.s.
Upper limit setpoint
up.L.s.
Lower limit range An1 only for linear
Lo.L.i.
Upper limit range An1 only for linear
up.L.i.
Automatic setting of linear input limits.
Latc.
Offset calibration
o.caL
Gain calibration
G.caL
Regulation type
act.t.
Command output reset type
c. re.
Contact state for command output in case
c. s.e.
of error
Define the OUT1 led state
c. Ld.
Hysteresis in ON/OFF or dead band in P.I.D.
c. HY.
Command delay
c. de.
Command setpoint protection
c. s.p.
Proportional band
p.b.
Integral time
t.i.
Derivative time
t.d.
Cycle time
t.c.
Limit of output power %
o.poL.
Alarm 1 selection
AL. 1
Alarm 1 output contact and intervention
A. 1 .s.o.
type
Reset type of alarm 1 contact.
A. 1 .re.
State of contact for alarm 1 output
A. 1 .s.e.
124
UR3274U - User manual
Model UR3274U:
System: