Table of Contents
Advertisement
Optional Equipment
National Instruments offers a variety of products for use with the NI 1429 and NI 1430, including
the following:
•
NI Camera Link I/O Extension Board for additional triggering, timing and I/O
(Part number 779352-01)
•
SMB to BNC cable, used for front panel trigger I/O (part number 763389-01)
Refer to the National Instruments catalog, visit ni.com, or call the National Instruments office nearest
you for specific information about these products.
Related Documentation
The following documents contain additional information that you may find helpful:
•
NI PCIe-1429 User Manual—Contains information about programming options, hardware
functionality, and signal connections.
•
NI PCIe-1430 User Manual—Contains information about programming options, hardware
functionality, and signal connections.
•
NI Vision Acquisition Software Release Notes—Outlines new functionality, system requirements,
installation procedures, and descriptions of the documentation included with the NI-IMAQ driver
software.
•
Measurement & Automation Explorer Help for NI-IMAQ—Describes how to configure the
NI-IMAQ driver software, NI image acquisition devices, and cameras using Measurement &
Automation Explorer (MAX).
•
NI-IMAQ Help—Contains fundamental programming concepts for the NI-IMAQ driver software
and terminology for using NI image acquisition devices.
Safety Information
Caution
The following paragraphs contain important safety information you must follow when
installing and operating the device.
Do not operate the device in a manner not specified in the documentation. Misuse of the device may
result in a hazard and may compromise the safety protection built into the device. If the device is
damaged, turn it off and do not use it until service-trained personnel can check its safety. If necessary,
return the device to National Instruments for repair.
Keep away from live circuits. Do not remove equipment covers or shields unless you are trained to do
so. If signal wires are connected to the device, hazardous voltages can exist even when the equipment is
turned off. To avoid a shock hazard, do not perform procedures involving cover or shield removal unless
you are qualified to do so. Disconnect all field power prior to removing covers or shields.
If the device is rated for use with hazardous voltages (>30 V
safety earth-ground connection wire. Refer to the device specifications for maximum voltage ratings.
Because of the danger of introducing additional hazards, do not install unauthorized parts or modify
the device. Use the device only with the chassis, modules, accessories, and cables specified in the
installation instructions. All covers and filler panels must be installed while operating the device.
Do not operate the device in an explosive atmosphere or where flammable gases or fumes may be
present. Operate the device only at or below the pollution degree stated in the specifications. Pollution
consists of any foreign matter—solid, liquid, or gas—that may reduce dielectric strength or surface
resistivity. The following is a description of pollution degrees.
Getting Started with the NI PCIe-1429 and 1430
, 42.4 V
rms
2
, or 60 V
), it may require a
pk
dc
ni.com
Advertisement
Table of Contents
