Table of Contents
Advertisement
Quick Links
WARNING:
• The input voltage for this fan should be 220V, 50Hz
• Electrical installation should be performed by a qualified electrician.
• To reduce the risk of electric shock, ensure electricity has been turned off before assembling
or disassembling. The assembling wire order must be Ground wire, live (supply) wire /neutral
wire, and the disassembling wire order should be neutral wire/ live (supply) wire, ground wire.
• Make sure all assembled screws were tight during the assembling.
• To reduce the risk of injury, do not touch the blade when the fan is running.
• The appliance is not intended to be used by children under the age of 8. It can be used by
children over the age of 8, as long as they are given continuous supervision.
• This appliance is not intended to be used by persons with reduced physical, sensory, or
mental capabilities, or lack of experience or knowledge, unless they have been given supervi-
sion or instruction concerning the use of the appliance in a safe way by a person responsible
for their safety, and understand the hazards involved.
• Supervise young children to make sure that they do not play with the appliance. Close super-
vision is necessary when the appliance is being used by or near children.
• Keep the appliance and its cord out of reach of children under the age of 8.
• Do not try to repair the appliance by yourself. Contact the official Technical Support Service
for advice.
• Cleaning and maintenance must be carried out according to this instruction manual to make
sure the appliance functions properly. Turn off and unplug the appliance before cleaning it.
• Proper grounding should be ensured throughout the installation.
• Installation should only be done by a certified electrician.
Advertisement
Table of Contents
Related Manuals for V-TAC VT-3042-3
Summary of Contents for V-TAC VT-3042-3
- Page 1 WARNING: • The input voltage for this fan should be 220V, 50Hz • Electrical installation should be performed by a qualified electrician. • To reduce the risk of electric shock, ensure electricity has been turned off before assembling or disassembling. The assembling wire order must be Ground wire, live (supply) wire /neutral wire, and the disassembling wire order should be neutral wire/ live (supply) wire, ground wire.
- Page 2 • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
-
Page 3: Technical Data
INTRODUCTION & WARRANTY DECORATIVE CEILING FANS (VT-3042-3) Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before start- ing the installation and keep this manual handy for future reference. If you have any... -
Page 4: Parts And Components
PARTS AND COMPONENTS 1. Mounting bracket 2. Down rod 3. Canopy 4. Fan body 5. Lampshade 6. Connector 7. Screw pack 8. Remote control 9. Screwdriver 10. Flat-blade screwdriver 11. 14 wrench Tools and material required (not included) 12. Herringbone ladder 13. -
Page 5: Step 1. Mounting Bracket Installation
IMPORTANT NOTES: 1. FAN WILL NOT START • Check the wire connections to the fan, ensure they are all correct. • Check and ensure the input wattage is correct to be 220V/50HZ. 2. THAN FAN SOUNDS NOISY • Make sure all assembled screws are tight. •... - Page 6 STEP 2. INSTALLATION OF THE HANGER SYSTEM • Get off the pin from the downrod by removing the R clip, and get the lead wire through the downrod, canopy and the connector, then seat the downrod into the fan body & rotate the the downrod until the holes on the downrod will match with the holes on the fan body, final- ly, you should get the pin through the holes and fix the pin by the R clip by another side (Fig.
-
Page 7: Step 3. Wiring Diagram
STEP 3. WIRING DIAGRAM FOR LIGHT L BROWN BROWN AC IN L BROWN AC L YELLOW GREEN FOR LIGHT N BLUE BLUE AC IN N BLUE AC N MOTOR PINK PINK MOTOR MOTOR GRAY AC:220-240V GRAY MOTOR RED WARNING: To avoid possible electrical shock, be sure elec- RECEIVER OF tricity is turned off at the main... - Page 8 Lift up the canopy to the ceiling for covering the mounting brack- FIG 6 et(make sure the canopy will seat into the two screws on the bracket), rotate the canopy to ensure the screw head are at the narrow end of the key holes, tighten the screws (Fig. 6). STEP 4.
- Page 9 REMOTE CONTROL SETTING OPERATION FAN ON/OFF 1. Restore electrical to the outlet box by LIGHT ON/OFF turning the electricity on at the main fuse box. Fan Speed 1 - Highest speed 2. Remove the battery cover from the 5 - Lowest speed remote control transmitter, install the bat- tery, and replace the cover.
- Page 10 BALANCE KIT BALANCE MAGNET PIECE In case of any query/issue with the product, please reach out to us at: support@v-tac.eu For More products range, inquiry please contact our distributor or nearest dealers. V-TAC EUROPE LTD. Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B...