Udp Variables; List Udp Settings (List Udp); Set Udp Enable (Enudp); Set The Udp Target Address And Port (Ipudp) - Scanivalve MPS4264 Hardware And Software Manual

MPS4264

UDP Variables

The UDP settings control the target and enable of scan data out the UDP port.

List UDP Settings (LIST UDP)

DESCRIPTION
SYNTAX
RETURNS
EXAMPLE

Set UDP Enable (ENUDP)

DESCRIPTION
SYNTAX
RETURNS
EXAMPLE
DEFAULT
RANGE

Set the UDP Target Address and Port (IPUDP)

DESCRIPTION
SYNTAX
RETURNS
EXAMPLE
DEFAULT
Returns all of the UDP settings
LIST UDP
All of the setting followed by the prompt.
LIST UDP
SET ENUDP 0
SET IPUDP 224.0.1.2
>
Sets the UDP Enable
SET ENUDP <0 or 1>
Prompt when ready to accept a new command
SET ENUDP 1
>
0
0 or 1
Sets the UDP target address and the port. After setting this value a SAVE must be issued and the
MPS4000 must be power cycled or rebooted for the changes to take effect.
SET IPUDP <udpadd> <port>
Where:
<udpadd> - Is the target address for the UDP scan data.
<port> - Is the target port.
Prompt when ready to accept a new command
SET IPUDP 224.0.1.2 23
>
0.0.0.0
57
Section 5: Software