Table of Contents
Advertisement
5..
IDE.connector.(40-1.pin.PRI_IDE)
The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are
three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard's IDE connector, then select one of the
following modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
• Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices.
P5N73-CM
P5N73-CM
If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the
same setting.
1-24
Drive.jumper.setting
Cable-Select or Master
Cable-Select
Master
Slave
cable connector. This prevents incorrect insertion when you connect the IDE cable.
IDE Connector
Mode.of.device(s)
-
Master
Slave
Master
Slave
PRI_IDE
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
Cable.connector
Black
Black
Gray
Black or gray
Chapter 1: Product introduction
Hide quick links:
Advertisement
Table of Contents
