Adjustment Of The Detector Position Of The Presser Foot Unit - Mitsubishi Electric PLK-J10050RH Technical Manual

7-2. Adjustment of the detector position of the presser foot unit

According to following procedures, adjust the detector position in case of parts replacement etc.
NOTE The presser foot lifting position is setting by 15 mm from top of the sliding plate.
NOTICE The presser foot movement is based on the origin detection position. To prevent the sewing
trouble and parts breaking, adjust the detector position exactly.
(1) Remove the eye guard (No.1) by referencing the previous paragraph [3-4. Installation of the eye
guard]
(2) Remove the three of fixing screws (No.2) and remove the face cover (No.3).
(3) Remove the needle (No.4).
<3>
<2>
<1>: Eye guard <2>: Fixing screw <3>: Face cover <4>: Needle
<4>
<1>
- 30 -