Panasonic Lumix DMC-F3P Service Manual page 34

NOTE:
When the following "AWB Results:" (without data) message is displayed instead of displaying the above "AWB Result
value list", try this adjustment again.
4. Compare the Value displayed on the PC monitor and the following table.
If the adjustment value is out of specification, replace the Lens unit and try it again.
5. After confirmation (Data comparison) has been completed, click on "OK".
[ AFTER ADJUSTMENT ]
NOTE:
If you want to perform other adjustments continiously, click on the pull down menu tag of the "Test" and choose the "OFF" in
stead of perform the following 1 to 3.
(The LCD display becomes black fade.)
Do not perform the same adjustment, continuously.
If it is necessary to perform the same adjustment, follow the following 1 to 3.
1. Close the "DscCalDi.exe" by clicking on the "X" located on the top right corner.
The LCD of the Camera unit becomes black fade.
2. Turn "off" the power switch of the camera unit.
3. Disconnect the USB cable.
34