Important Notice 1 - Panasonic Lumix DMC-F3P Service Manual

3.3.

Important Notice 1:

[1.Component on P.C.B.]
1. The P.C.B.'s in this unit is not component replacement excluding following part.
MAIN P.C.B. --------- Fuse (F5001, F5002, F5005, F5006)
FLASH P.C.B. -------- Flash Charging Capacitor(C5412)), Trigger Coil(T5402)
Other than above component on P.C.B.'s are defected, replace each P.C.B. as a unit.
[2.MAIN P.C.B.]
AFTER REPLACING THE MAIN P.C.B.
After replacing the Main P.C.B., follow the following steps in order.
1. Assemble the unit.
Refer to the "7.Disassembly and Assembly Instructions" section.
2. Up date the firmware.
The firmware together with version up procedure are available at "software download" on the "Support Information from
NWBG/VDBG-AVC" web-site in "TSN system".
3. Perform the adjustment using adjustment software "DscCalDi".
The adjustment software is available at "software download" on the "Support Information from NWBG/VDBG-AVC" web-site in
"TSN system".
4. Register the USB storage information.
Refer to the "8.4.6.USB STORAGE INFO. REGISTRATION" in "8.4.Adjustment procedures" section.
5. Set the "model suffix".
Refer to the "3.4.2.INITIAL SETTINGS:" section.
6. Refresh the unit.
Refer to the "3.4.2.INITIAL SETTINGS:" section.
[3.Lens unit]
1. The Lens unit in this unit is not component replacement.
Other than above part are defected, replace minimumsize of concerned part as a unit.
9