Marsh TD2100 Technical Manual page 39

Removing the Movable Cutter Assembly
To replace the movable cutter assembly, see Fig 19 and follow the steps below.
1. Turn the switch to OFF and unplug the machine.
2. Removing the Right Side Cover [p. 20]).
3. Remove the left side cover (refer to Removing the Left Side Cover [p.
4. Remove the pinch roller (refer to Removing the Pinch Roller [p. 26]).
5. Remove the weighted brush cover (refer to Removing the Weighted
6. Remove the tape channel plate (refer to Removing the Tape Channel
7. Remove the water tank holder (refer to Removing the Water Tank
8. Remove the cutter arms (refer to Removing the Cutter Arms [p. 36]).
9. Rotate the movable cutter assembly towards the front of the machine.
10. Twist the movable cutter assembly and remove from the machine.
The movable cutter assembly is now removed from the machine. At this point
a new movable cutter assembly may be installed.
Attaching the Movable Cutter Assembly
To replace the movable cutter assembly, see Fig 19 and follow the steps below.
1. Place the movable cutter into the precut slots in the chassis at an angle.
2. Untwist the movable cutter assembly and rotate the movable cutter
3. Attach the cutter arms (refer to Attaching the Cutter Arms [p. 36]).
4. Attach the water tank holder (refer to Attaching the Water Tank
5. Attach the tape channel plate (refer to Attaching the Tape Channel
6. Attach the weighted brush cover (refer to Attaching the Weighted
7. Attach the pinch roller (refer to Attaching the Pinch Roller [p. 26]).
8. Attach the left side cover (refer to Attaching the Left Side Cover [p.
9. Attach the right side cover (refer to Attaching the Right Side Cover
The machine is now ready to continue normal operation.
Marsh Shipping Supply Co. LLC; Collinsville, IL 62234 U.S.A.; Tel: 618.343.1006 Fax: 618.343.1016
22]).
Brush Cover [p. 28]).
Plate [p. 30]).
Holder [p. 34]).
assembly upwards.
Holder [p. 30]).
Plate [p. 28]).
Brush Cover [p. 26]).
22]).
[p. 20]).
39
09/21/2016
41910