Productos McLand GARLAND GEISER 401 Q Instruction Manual page 24

English
6.5. CHECKING POINTS AFTER START UP
Check that there is no air in the aspiration hose.
Check that all the racors are correctly tightened and
that there are no water leakages on the main body of
the pump, through the racors or in the impulsion hose.
6.6. END OF USAGE
After using the machine, empty the water that is
inside the machine. To do this, unscrew the emptying
water screw and wait for the water to empty from the
machine. After this, screw back into place.
7. MAINTENANCE AND SERVICE
The objective of the maintenance and service is to
ensure that your machine works always in the best
possible conditions both in efficiency and security.
Follow the recommendations and the maintenance
periods included in this manual.
Turn off the engine before doing any adjustments,
change of accessories or storing the
machine.
Action
After
every
use
•
Check level
Engine oil
Change
Check •
Air filter
Clean
Spark plug Clean/Adjust
Deposit filter
Clean
After 20 Every Every Every
hours 50 100 300
work hours hours hours
or one or 3
or 6 or
month months months each
year
• • •
• • •
• •
•
7.2. OIL CHANGE
To do the oil change, the oil must be hot to guarantee
that oil filters out correctly and quickly. If you are
going to change the oil, do so after using the machine
if not you will have to start the machine for a few
minutes prior to changing the oil so as to heat the oil.
Remember that the machine should not be started
with the pump empty (the pump must be filled up with
water).
Oil change:
1. Stop the machine.
2. Place the
machine in a
horizontal position
and in such a
way that the oil drains
out into
recipient. Remember
that this machine
has a capacity for 0.4 l and therefore the recipient
must have at least this volume.
3. Remove the oil cap.
4. Unscrew the oil emptying screw. Oil will start to
drain out. Do not touch the oil. The oil could be very
hot and could burn you. Oil can also irritate your skin.
5. When oil has stopped draining out, wait a few
minutes more to ensure that the last drops of oil
drain out.
6. Check that the oil emptying screw and its joint are
in perfect state. If not, change them.
7. Screw the emptying oil screw and joint back into
place.
8. Add 0.4 l of new and clean 20W-40.
9. Start the engine for a minute (remember to fill the
machine with water).
10.Check the oil level and if necessary, refill.
Please collect the used up oil in an adequate
recipientfor transporting used up oil and take it to a
recycling centre nearest to you. Do not throw the oil
on the floor or the sewer.
24/92
a