Connecting Cables; Precautions On Connecting/Disconnecting Cables; Connecting Lan Cables; Connecting The Power Cord - Fujitsu Supercomputer PRIMEHPC FX700 Operating Manual

Chapter 3 Starting Up
3.16 Powering On for the First Time
3.15

Connecting Cables

This section contains precautions and information on connecting cables.
3.15.1

Precautions on Connecting/Disconnecting Cables

- Always read the documentation supplied with the device you want to connect. Never connect or
disconnect cables during a thunderstorm. Never pull on a cable when disconnecting it. Always hold
the cable by the plug.
- If your finger is too big to touch the connector lock when disconnecting a LAN or other cable, the
cable cannot be removed. In that case, unlock the connector lock by pushing it with a flathead
screwdriver. Then, remove the cable by pulling it and the screwdriver out together.
Information for Ensuring Electromagnetic Compatibility
All the cables must have sufficient shielding. The recommended cable type is S/FTP Cat5 or higher.
Use of unshielded or badly shielded cables may lead to increased emission of interference and/or reduced
fault-tolerance of the device.
3.15.2

Connecting LAN Cables

The following is the procedure for connecting LAN cables.
1. Connect the LAN cables to the LAN ports.
For details on the LAN ports on the FX700 main unit, see
2.
Check the port LEDs.
See "1.2.2.2 Rear LAN LEDs on the
3.15.3

Connecting the Power Cord

At the basic configuration level, the FX700 main unit has two PSUs mounted.
You can ensure a redundant supply of power by adding a third PSU.
1. Connect the power cord to the PSU.
2. Connect the main power plug to the power strip.
Confirm that the PSU status LED is blinking in green.
See "1.2.2.4 PSU
3.16

Powering On for the First Time

This section describes AC power-on and how to configure various settings.
Blade."
LED."
50
"1.1.4 LANs of the FX700 Main
C120-0089-02EN
Unit."