Chapter 3 Starting Up
3.9 Installing/Removing the Blade
Remarks
Push the device until it is locked.
Note
- At any location where no blade will be mounted, a dummy blade must be installed.
For details on how to install a dummy blade, see
- When inserting the blade, be careful not to allow foreign objects, such as cables, to enter the chassis.
3.9.2
Removing the Blade From the Chassis
The following is the procedure for removing the blade from the chassis.
1.
While the lock is unlocked (1), pull the handle (2) to remove the blade from the chassis.
Figure 3.19 Installing the Blade
Lock
"3.11.1 Installing the Dummy Blade in the
41
Chassis."
C120-0089-02EN