Philips LC4.8A Service Manual page 10

EN 10 4. LC4.8A AA
4.3.3 LED Panel
2
Figure 4-6 LED panel
1. Remove the fixation screws (1) and take the panel out of its
brackets.
2. Disconnect the cable (2) from the panel.
4.3.4 Keyboard Control Panel
Figure 4-7 Keyboard control panel
1. Remove the panel (1) from its brackets (2).
2. Disconnect the cable (3) from the panel.
Mechanical Instructions
1
F_15420_036.eps
2
1
3
F_15420_037.eps
4.3.5 SSB Board Cover Shield
070605
Figure 4-9 VGA connector and rear I/O panel screws
1. Very cautiously disconnect the LVDS cable (1) from the
SSB panel (see Figure "SSB board cover shield"). Notice
that this cable is very fragile.
2. Remove all other cables (2) from the SSB board (see
Figure "SSB board cover shield").
3. Remove the fixation screws (3), see Figure "SSB board
cover shield" and remove the SSB shield with the SSB
board inside, and the rear I/O panel still attached to it.
4. Remove the fixation screws (3) from the VGA connector
and from the rear panel, see Figure "VGA connector and
rear panel screws", and remove the rear I/O panel from the
SSB board.
5. Remove the upper part of the shield from the SSB panel,
by unhooking it from its brackets. Be careful not to damage
the LVDS connector on the SSB board, see Figure "SSB
board cover shield".
4.3.6 SSB
070605
1. Remove the two fixation screws (1) that secure the SSB
board on the lower part of the SSB shielding, see Figure
"SSB".
2. Remove the SSB panel.
2
1
3
Figure 4-8 SSB cover shield
3 3
1
Figure 4-10 SSB
3
F_15420_038.eps
070605
F_15420_040.eps
070605