Kingfisher DDD500WT151DA Instruction Manual page 16

SETTING THE TEMPERATURE OFFSET
This setting compensates for any difference (offset) between the tempera-
ture displayed by the unit and ambient temperature measured in the room.
This difference varies from one room to another as it depends on the insu-
lation, room layout and location of the appliance.
This difference must be closed when the ambient temperature is stabilised
after more than 2 hours of heating in Comfort or Eco mode.
This setting changes neither the stability nor the accuracy of the tempera-
ture regulation.
- Press MENU, then + to access the OFS menu.
- Press OK-boost to enter this menu.
- Press + or - to set the offset between 8°C and -8°C
- Press OK-boost to validate the offset.
- Press MENU to exit the menu.
For example, if the appliance is set at 20°C and if the ambient thermometer
displays 18°C, the offset must be -2°C.
For example, if the appliance is set at 20°C and if the ambient thermometer
displays 22°C, the offset must be 2°C.
DEROGATION (Prolonged absence)
. This function maintains frost protection mode at
7.5°C during a prolonged absence then returns to
the initial settings.
- Press MENU, then + to access the dEr menu.
- Press OK-boost to enter this menu.
- Press + or - to select the number of days of absence from 1 to 99 days (for
example, 5 days = 05.d).
The current day must be counted as an absence day.
- Press OK-boost to activate the absence setting; the number of remaining
days is displayed alternately with the setpoint temperature.
The initial mode (Comfort, Eco or Programme) is re-established at midnight
on the last day of absence.
- Press MENU to cancel the absence function.
For example, if the absence is programmed on Monday for 3 days, the ap-
pliance will remain in frost protection mode until Wednesday at midnight.
16
Quick start