Operation - KRAUSE & BECKER 69584 Owner's Manual & Safety Instructions

Delayed or inadequate cleaning will permanently clog the Spray Gun.
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Power Switch/Trigger is in the off-position and unplug the tool
from its electrical outlet before performing any procedure in this section.
Paint Preparation and Filling
Note: Proper paint mixture is essential.
Follow the manufacturer's directions.
Most paints will spray easily if they are thinned properly.
1. Thin the paint according to manufacturer's
directions and mix thoroughly.
2. Carefully strain the paint through
a paint strainer or a piece of cheesecloth.
Page 8
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
For technical questions, please call 1-800-444-3353.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Before spraying, mask nearby objects not being
sprayed and lay cloths (not included) on the floors.
3. Fill the Cup to 3/4 full. Close Cup.
4. Test the consistency by spraying on
a piece of scrap material.
If it still appears too thick, add a very small amount
of thinner (not included) and mix thoroughly.
Use the proper thinner for the type of paint.
Thin CAUTIOUSLY. Proceed slowly, adding
minimal amounts at a time. DO NOT exceed the
manufacturer's thinning recommendations.
Item 69584