Table of Contents
Advertisement
3610J and 3620J Positioners
ACTUATOR
ROD
TURNBUCKLE
SPLINED END
OF SHAFT
LEVER CLAMPING
BOLT
CAM (KEY 82)
48A7851−C
C0572−2/IL
Figure 3. Typical Mounting Details for 3610J and 3620J Series Positioners on Rotary Actuators
Changing Cams—Actuator Styles A, B,
C, and D
During the following procedures, refer to figure 3 for
part locations and refer to figure 28 for key number
locations unless otherwise indicated.
1. Mark the positions of the travel indicator and
actuator cover. Then, remove the actuator travel
indicator machine screws, travel indicator, and
actuator cover cap screws.
2. Remove the positioner plate from the actuator
housing.
10
TRAVEL INDICATOR
14A7222−G
ACTUATOR WITHOUT POSITIONER
LEVER ARM
ROLLER (KEY 39)
CAM ADJUSTMENT INDICATOR
(KEY 84, NOT USED ON CAM A)
STYLE A OR D
ACTUATOR AND POSITIONER WITH ACTUATOR COVER REMOVED
ACTUATOR
COVER
POSITIONER
PLATE
14A7224−D
POSITIONER COVER
(KEY 41)
FEEDBACK LEVER
ASSEMBLY (KEY 117)
CAM MOUNTING
MACHINE
SCREWS (KEY 83)
58A7810−W
3. For actuator styles A and D, proceed to the note
before step 7. For actuator styles B and C, continue
with step 4.
4. Disconnect the actuator turnbuckle from the lever
arm.
Do not change the position of the rod
end bearing on the end of the
turnbuckle.
5. Loosen the lever clamping bolt in the lever.
Instruction Manual
June 2008
FEEDBACK
LEVER
ASSEMBLY
(KEY 117)
11B4045−A
CAM
(KEY 82)
STYLE B OR C
Note
Advertisement
Table of Contents
