Apm Configuration; Usb Configuration - Asus H310I-IM-A R2.0 Manual

Dynamic Digital IO
The items listed in this screen configure Digital IO settings.
DIO 0~7 [Input]
Configuration options: [Input] [Output]
The following item appears only when you set DIO 0~7 to [Output].
Output Level [H]
Configuration options: [H] [L]
3.3.9

APM Configuration

ErP Ready [Disabled]
Allows BIOS to switch off some power at S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options will be switched off.
Configuration options: [Enable(S4+S5)] [Enable(S5)] [Disabled]
Restore AC Power Loss [Power Off]
[Power On]
[Power Off]
[Last State]
Power On By PCI-E [Disabled]
This item allows you to enable or disable the Wake-on-LAN function of the onboard
LAN controller or other installed PCIe LAN cards. Configuration options: [Disabled]
[Enabled]
Power On By RTC [Disabled]
This item allows you to enable or disable the RTC (Real-Time Clock) to generate
a wake event and configure the RTC alarm date. When enabled, you can set the
days, hours, minutes, or seconds to schedule an RTC alarm date. Configuration
options: [Disabled] [Enabled]
CEC Ready [Disabled]
Enable this item to allow your system to comply with CEC (California Energy
Commission) regulations to save some power at S0 state. Configuration options:
[Enable] [Disabled]
3.3.10

USB Configuration

The USB Devices item lists auto-detected values. If no USB device is detected,
the item shows None.
3-12
The system goes into on state after an AC power loss.
The system goes into off state after an AC power loss.
The system goes into either off or on state, whatever the system
state was before the AC power loss.
H310I-IM-A R2.0