mLogic mRack DIT Manual page 12

11
Verify your mRack DIT is recognized by your Mac
1) Under "About this Mac" > "System Report..." verify that the mLogic SAS Controller and
ULTRIUM-HH inside of mRack DIT are displayed under the "SAS" entry as shown below.
If the mLogic SAS Controller is not displayed, make sure you have installed the mLogicDITv2.dmg
driver. Once mRack DIT is powered on, it takes approximately 20 seconds for the ULTRIUM-HH
to show up in the "SAS" entry.
If you have issues with mRack DIT being recognized by your system, please contact
support@mlogic.com.